





Create this beautiful pendant inspired by the spirograph and string art from days gone by. Start with a notched washer blank and learn the weave which will entrap and support your Swarovski crystal stone. Don’t be intimidated - it is easier than it looks!
Lisa's Note: "There isn't a hard rule about how many notches to skip, you can skip less to expose more of the stone or more to cover more of the stone...ya just have to remember to skip enough so that actually entrap and hold the stone enough to keep it from falling out. As a quick reference: on the small 3/4" washers I tend to skip about 6 notches and go into the 7th notch - and on the larger 1 3/8" washers I skip 10 and go in on the 11th."
This class has a run time of 32 minutes.
-
Clear nail polish
-
To make a 1 inch Spiro pendant you will need:
-
28 gauge wire - You'll need 4.5 feet
-
Jump ring -Lisa uses a 18 gauge, 3.5mm or 4mm I.D. jump ring
-
To make a 3/4 inch Spiro pendant you will need:
-
28 gauge wire -You'll need 30 inches
-
Jump ring -Lisa uses a 18 gauge, 3.5mm or 4mm I.D. jump ring
-
To make a 1 3/8 inch Spiro pendant you will need:
-
28 gauge wire -You'll need 6.5 feet
-
Jump ring -Lisa uses a 18 gauge, 3.5mm or 4mm I.D. jump ring
-
Thread to practice the weave
-
Metal Hole Punch Plier, 1.5mm hole - $14.00 - The notched washers come with one hole for a jump ring. Lisa recommends this tool If you would like to make additional holes as shown in the Design Ideas step.
Thank you!
I will indeed be to doing this one.
Loved it. Cheers
Thank you, Lisa!
Peg